| View previous topic :: View next topic |
| Author |
Message |
cabbie
3rd gear
Joined: 14 May 2009
Posts: 232
|
 Posted: Tue Oct 13, 2009 9:05 pm Post subject: Pump priming? |
 |
|
I've got the pump fitted up but I can't seam to get a follow of oil from pipes two and three, just a few air bubbles, pipe one is pumping ok.
Is there a set procedure for this? I tried revving the engine and holding the pump open full.
PS it's still running on pre-mix before you all start shouting! 
|
|
| Back to top |
|
 |
The Wolfman
5th gear
Joined: 24 Oct 2007
Posts: 820
Location: South, North and East Yorkshire, It's a big place!
|
| Posted: Tue Oct 13, 2009 10:22 pm Post subject: |
|
|
Did you bleed the inlet pipe right up to the pump banjo?
I usually lift the pump and put a drill on the drive, then you can play all day with no engine running, the pumps can take ages to fully prime sometimes.
but yep, hold the lever fully open.
_________________
:
I used to be a Werewolf, but I'm alright Noooowwwwww!! |
|
| Back to top |
|
|
BIG AL
4th gear
Joined: 25 Sep 2007
Posts: 406
Location: W Yorkshire
|
| Posted: Tue Oct 13, 2009 10:25 pm Post subject: Re: Pump priming? |
|
|
| cabbie wrote: | I've got the pump fitted up but I can't seam to get a follow of oil from pipes two and three, just a few air bubbles, pipe one is pumping ok.
Is there a set procedure for this? I tried revving the engine and holding the pump open full.
PS it's still running on pre-mix before you all start shouting! |
that should be doing the trick cabbie , i bleed mine through on idle and saw the oil line fill up almost straight away, check the banjos again they might need nipping up again
_________________
BIG AL
If All Else Fails (Hit it with a big hammer) |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Join! (free) 
Profile
Log in to check your private messages
Log in
