cabbie
|
Pump priming?I've got the pump fitted up but I can't seam to get a follow of oil from pipes two and three, just a few air bubbles, pipe one is pumping ok.
Is there a set procedure for this? I tried revving the engine and holding the pump open full.
PS it's still running on pre-mix before you all start shouting! 
|
The Wolfman
|
Did you bleed the inlet pipe right up to the pump banjo?
I usually lift the pump and put a drill on the drive, then you can play all day with no engine running, the pumps can take ages to fully prime sometimes.
but yep, hold the lever fully open.
|
BIG AL
|
Re: Pump priming? | cabbie wrote: | I've got the pump fitted up but I can't seam to get a follow of oil from pipes two and three, just a few air bubbles, pipe one is pumping ok.
Is there a set procedure for this? I tried revving the engine and holding the pump open full.
PS it's still running on pre-mix before you all start shouting! |
that should be doing the trick cabbie , i bleed mine through on idle and saw the oil line fill up almost straight away, check the banjos again they might need nipping up again
|
|
|
|